Tag: Cisco 200-125 Real Exam

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.221You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the maximum number of subnets. Which network address and subnet mask meet this requirement?A.192.168.252.0 255.255.255.252B.192.168.252.8 255.255.255.248C.192.168.252.8 255.255.255.252D.192.168.252.16 255.255.255.240E.192.168.252.16 255.255.255.252Correct Answer: BExplanation:A subnet Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.211Which two of these statements are true of IPv6 address representation? (Choose two.)There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.A single interface may be assigned multiple IPv6 addresses of any type.Every IPv6 interface contains at least one loopback address.The first 64 bits represent the dynamically created interface ID.Leading zeros in an IPv6 16 bit hexadecimal field are Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.191What will happen if a private IP address is assigned to a public interface connected to an ISP?Addresses in a private range will not be routed on the Internet backbone.Only the ISP router will have the capability to access the public network.The NAT process will be used to translate this address to a valid IP address.A conflict of IP addresses happens, because other public routers can use the same range.Correct Answer: Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.181What is the purpose of Inverse ARP?to map a known IP address to a MAC addressto map a known DLCI to a MAC addressto map a known MAC address to an IP addressto map a known DLCI to an IP addressto map a known IP address to a SPIDto map a known SPID to a MAC addressCorrect Answer: DExplanation:Dynamic address mapping relies on the Frame Relay Inverse Address Resolution Protocol (Inverse ARP), defined by RFC 1293, to Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.171Which two statistics appear in show frame-relay map output? (Choose two.)the number of BECN packets that are received by the routerthe value of the local DLCIthe number of FECN packets that are received by the routerthe status of the PVC that is configured on the routerthe IP address of the local routerCorrect Answer: BDExplanation:Sample quot;show frame-relay mapquot; output: R1#sh frame mapSerial0/0 (up): ip 10.4.4.1 Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.161Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?The maximum number of bytes that can traverse this interface per second is 1500.The minimum segment size that can traverse this interface is 1500 bytes.The maximum segment size that can traverse this interface is 1500 bytes.The minimum packet size that can traverse this interface is 1500 bytes.The maximum packet size that can traverse this interface Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.151Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two.)Router(config)# router ospf 0Router(config)# router ospf 1Router(config)# router ospf area 0Router(config-router)# network 192.168.16.0 0.0.0.255 0Router(config-router)# network 192.168.16.0 0.0.0.255 area 0Router(config-router)# network 192.168.16.0 255.255.255.0 area 0Correct Answer: Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.141Refer to the exhibit. What is the reason that the interface status is quot;administratively down, line protocol downquot;?There is no encapsulation type configured.There is a mismatch in encapsulation types.The interface is not receiving any keepalives.The interface has been configured with the shutdown command.The interface needs to be configured as a DTE device.The wrong type of cable is connected to the interface.Correct Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.131Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? (Choose two.)Router1 has specific boot system commands that instruct it to load IOS from a TFTP server.Router1 is acting as a TFTP server for other routers.Router1 cannot locate a valid IOS image in flash memory.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.Cisco routers will Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.121Refer to the exhibit. Why is flash memory erased prior to upgrading the IOS image from the TFTP server?The router cannot verify that the Cisco IOS image currently in flash is valid.Flash memory on Cisco routers can contain only a single IOS image.Erasing current flash content is requested during the copy dialog.In order for the router to use the new image as the default, it must be the only IOS image in flash.Correct Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.111Which statements describe the routing protocol OSPF? (Choose three.)It supports VLSM.It is used to route between autonomous systems.It confines network instability to one area of the network.It increases routing overhead on the network.It allows extensive control of routing updates.It is simpler to configure than RIP v2.Correct Answer: ACEExplanation:The OSPF protocol is based on link-state technology, which is a Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/200-125.html Question No.101DRAG DROPCorrect Answer: Question No.102Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server.Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure?The network has not fully Read more [...]