[Free] 2019(Nov) EnsurePass Cisco 200-355 Dumps with VCE and PDF 41-50

Get Full Version of the Exam
http://www.EnsurePass.com/200-355.html

Question No.41

An engineer wants to deploy a 2504 controller as the anchor controller for a guest WLAN that resides on a 5508 controller in a different mobility group. What configuration change must be applied to support this deployment strategy?

  1. UDP 16666 and IP Protocol 97 must be enabled on the 2504 controller

  2. UDP 5246 and TCP Protocol 97 must be enabled on the router

  3. The 2504 controller must be added to the same mobility group as the 5508.

  4. DHCP Option 43 must be added to the neighboring switchport

Correct Answer: C

Question No.42

Which of the following are three functions of Cisco RRM? (Choose three.)

  1. TPC

  2. intercontroller roaming

  3. dynamic channel assignment

  4. intracontroller roaming

  5. coverage hole detection

Correct Answer: ACE

Question No.43

An engineer has been asked to upgrade the FUS on the Wireless LAN controller. How can they monitor the status of the upgrade?

  1. WLC GUI

  2. WLC CLI

  3. WLC Console

  4. WLC Management in Prime Infrastructure

Correct Answer: C

Question No.44

Refer to the exhibit. At which point in the network topology must the trunk be configured to support multiple SSIDs for voice and data separation?

image

  1. A

  2. B

  3. C

  4. D

Correct Answer: D

Question No.45

After installing a Cisco 5508 Wireless Controller using the default settings, how often will the RRM update occur?

  1. 30 seconds

  2. 60 seconds

  3. 300 seconds

  4. 600 seconds

  5. 3600 seconds

  6. 7200 seconds

Correct Answer: D

Question No.46

An engineer is conducting an active survey for indoor coverage in a warehouse. The warehouse has long aisles with racks that extend to the ceiling. Which antenna type has a radiation pattern that is suited to provide coverage in each aisle?

  1. Yagi

  2. patch

  3. omnidirectional

  4. dipole

Correct Answer: B

Question No.47

Refer to the exhibit. WLC1 becomes unresponsive due to a power failure at a customer site. How does the access point that is shown in the WLC controller GUI behave now that WLC1 is disabled?

image

  1. associates to controller 10.201.204.6

  2. associates to controller 10.201.204.11

  3. associates to controller 10.201.204.8

  4. associates to controller 10.201.204.19

Correct Answer: B

Question No.48

Refer to the exhibit. Which two wireless functions is the client experiencing? (Choose two.)

image

  1. Inter-controller Roaming

  2. Intra-controller Roaming

  3. Layer 2 Roaming

  4. Layer 3 Roaming

  5. Inter-subnet roaming

  6. Re-authentication

Correct Answer: BC

Question No.49

What is the EIRP value for a transmitter that has a transmitter capable of 15 dBm, an antenna that has a gain of 12 dBi, and a cable that connects the transmitter to the antenna that has 1 db loss?

  1. 26 dBm

  2. 100 mW

  3. .86 dBm

  4. 165 dBm

  5. 1000 mW

Correct Answer: A

Question No.50

A controller is connected to a Cisco Catalyst switch. The switch port configuration looks like this:

interface GigabitEthernet 1/0/10 switchport

switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,20,30,50 switchport trunk native vlan 20 switchport mode trunk

Which controller CLI command assigns its management interface to the native VLAN interface of the Cisco Catalyst switch?

  1. config interface vlan management 0

  2. config interface vlan management 1

  3. config interface vlan management 20

  4. config interface vlan management 30

  5. config interface vlan management 50

Correct Answer: A

Get Full Version of the Exam
200-355 Dumps
200-355 VCE and PDF